If you have enough do-it-yourself smarts to have recognized that something is wrong with the adjustment of the springs on your garage door, but you’re at a loss when you think about trying to fix the problem, take heart! It is a bit complicated to handle this repair job yourself, but you can do so without having to pay a lot of money for a professional to do it. If you are interested in adjusting the springs found in your garage door, then you need to pay attention to some of the following points.
Although there are other types of springs, the type we’re talking about here is torsion springs. In order to open your garage door, torsion springs will generate torque by twisting. You should know that the definition of torque is the amount of force necessary to rotate an object around its axis. Most of the force necessary to make your garage door go up and down is produced by these components. A garage door that isn’t fitted with an automatic opener will still make use of springs. You will find torsion springs at the top of your garage door. The springs are responsible for winding up the cables that actually lift up the bottom of the door.
Among the different pieces of equipment that you will need include a ladder, two tension rods, and a 7/16-inch wrench. Stop long enough to get a feel for the different parts of your door opening apparatus. Once you’ve done this, find the reddish-colored cone that is around the spring on the left hand side of the torsion spring. Examine it for notches and screws. Take one of the tension rods and shove it firmly into the first notch. This will hold the cone and provide you with a safety measure which will stop the spring from snapping back into your face when you loosen the screws.
Now is the time to use the wrench that you have to loosen the two set of screws. It is vital that you have the tension rods in place to make sure that you don’t get injured. After you’ve loosened the screws, place the other tension rod into another notch on the same cone. Hold the rods, and you’ll be able to move the cone either to the left to loosen it or to the right in order to tighten it. After all of the adjustments have been made, you will need to remove just one of the tension rods before you start to tighten the screws again. Tightening the screws will ensure that your new adjustments will be saved.
Kristie Brown writes on a variety of topics from health to technology. Check out her websites on Garage Doors Madison WI and Garages.
